[. . . ] The angle of the bottom cymbal can be adjusted by turning the angle bolt on the underside of the support plate. [. . . ] Please read this owner's manual thoroughly before use. To install the top hi-hat cymbal, loosen the wing bolt and remove the entire hi-hat clutch assembly from the upper pull rod. Next, remove the clutch nut and position the cymbal between the two clutch felts. After installation, tighten the clutch nut on to the clutch assembly to secure the cymbal. lithium grease) to all of the moving parts as needed. e Position Clamp Once the bottom hi-hat cymbal height has been decided, the position clamp can be used to mark the settings for future set ups and to prevent unintentional changes during musical performances. Use a drum key to firmly tighten the position clamp into place. Position Clamp Extender Base · r Footboard Stabilizer Rod The Footboard stabilizer rod should attach to holes in the frame at the bottom of the hi-hat base. * Specifications and design are subject to change without notice. t Spur The large heavy-duty rubber feet prevent unwanted movement of the hi-hat stand during playing conditions. These spurs can be extended as needed by adjusting the turn screws provided on either side of the frame base. Footboard Note: To maintain smooth action, occasionally apply some grease-grade oil to all of the moving parts. [. . . ] These spurs can be extended as needed by adjusting the turn screws provided on either side of the frame base. Footboard Note: To maintain smooth action, occasionally apply some grease-grade oil to all of the moving parts. [. . . ]